Upgrade Magnetic Steel Sheet Base Soft Surface Plate Post for 3D Printer Hot Bed Print Tape Heatbed Sticker Non PEI MY3D
$20.40 – $44.41
1. Products are divided into A.B.C boards.
A Plate: strong magnetic composite magnetic stickers, movable and bendable, easy to take the printing mold. 1MM thick.
B Plate: 0.5mm thick, special magnetic stainless steel plate.
C board: 3mm thick aluminum board 24v DC 250W power heating PCB board.
D Lattice glass-nano coating thickness 4mm size 220*220mm PLA-hot bed temperature 50-60 ℃ ABS 80-110 ℃, the cooling model is naturally separated. Relatively soft magnets are more durable and temperature resistant. The highest temperature can reach 500℃. Flatness is less than 100μm
Can not be used alone A
A magnetic sticker must be used together with B magnetic steel plate,
A The magnetic stickers of the hot bed are made of special plastic, and the maximum temperature resistance is 120 ℃ (more than will melt and damage)
Please do not directly heat the nozzle when it is close to the hot bed when the nozzle is preheating (preheating)
The correct method is: adjust the nozzle preheating bed distance 10mm and then preheat the nozzle,
If printing PLA hot bed temperature is 50-60 ℃, you can directly remove the magnet A after printing, and remove the printed model after bending.
It is recommended to set the temperature of the hot bed:
PLA bed hot bed temperature: 50-60 ℃. At 60 degrees Celsius, the model PLA and the magnetic stickers are more viscous, and the mold needs to be removed slightly cold.
For ABS material, the recommended hot bed temperature is 60-100 ℃. After the printing is completed, the mold needs to be cooled to 50-60 ° C,
(In the case of high temperature, the adhesion between the printed model and the surface of the magnet is relatively strong. Forcibly detaching the model, it is easy to damage the magnet. It needs to be cooled to 50-60 ℃, and then bent to take the mold
C HOT BED PCB
Model: 6061 aluminum plate 3mm thickness flatness is + -0.01mm.
Heating method PCB circuit board, input 24v output power 250w
Temperature measurement method: NTC-100 temperature sensing measurement range -50- +125℃ ,
screw hole M3 screw length 45mm
1. The A board magnetic stickers cannot be used alone,
2. Paste B plate: magnetic steel plate.
Please wipe the surface of the hot bed C plate platform with alcohol, etc. to keep it clean.
Carefully tear off the 3M protective film of the B board, then align the C board, press and flatten,
* Be careful not to forcibly bend the B-plate magnetic steel plate, if it is hardly bent, it is difficult to recover.
* Note that the B board 3M compound adhesive is a high temperature resistant 130 ° high strength adhesive. It is difficult to separate after compounding with the hot bed. Please align the size and press hard (one chance).
After the B board is bonded to the C board (3mm thick hot bed), remove the blue protective film of the B board and use it normally.
Specification: Upgrade Magnetic Steel Sheet Base Soft Surface Plate Post for 3D Printer Hot Bed Print Tape Heatbed Sticker Non PEI MY3D